For only 9.99$/year you can upgrade your account to RCTen Factory Team Member. Click for all benefits.
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Tuning in a Punch (Last 5%)

Discussion in 'Nitro Engines and Tuned Pipes Section' started by tmail61, Jun 4, 2012.

  1. tmail61

    tmail61 Well-Known Member Factory Member

    Joined:
    Jun 1, 2012
    Messages:
    4,446
    Likes Received:
    916
    John Adams

    Fine Tuning in a Punch

    On high traction tracks instant throttle response and acceleration are the keys to being competitive. To get that last 5% of performance through tuning, many top drivers and engine tuners use the punch test. Here's how it works.

    With the high speed needle properly set and the low speed needle set per the pinch test, run several laps at race pace to bring the engine up to temperature. Now stop the car at the beginning of the main straight and allow it to idle while you count to 15. At the count of 15, hit the throttle instantly full punch while carefully listening to the engine and note the rate of acceleration. If you did a good job with the pinch test above and the high-speed needle is properly set as described below, the car should rocket off the line with a powerful, crisp consistent engine sound. The trick here is to tune the low speed needle for even greater acceleration and an even crisper throttle response. Do this punch test several times until your very familiar with the acceleration rate (it helps to judge the amount of wheel spin) and the sound of the engine as it accelerates to full throttle. Now lean the low speed needle 1 hour (or 1/12th of a turn) and do the punch test again. Is the engine's acceleration rate and the crisp consistent sound better than in the previous test? Remember judging the wheel spin (the amount the wheels slip during heavy acceleration) is a good way to compare. If it's better or there's no change, lean the low speed needle 1 hour more and try the punch test again. At some point the engine will lean bog (hesitate) off the line during acceleration indicating that you've gone too far.

    When you finally find this point through repeated punch tests then leaning the low speed needle one hour each time, richen the low speed needle 2 hours. This will be your engines peak setting giving maximum acceleration and throttle response for the specific conditions of the day. Just remember if you change anything, like gear ratios, clutch settings, exhaust systems, fuel, glow plugs and even changing atmospheric conditions like temperature and barometric will cause this optimum setting to change. Repeat the punch test often and especially just before a heat race to ensure maximum performance during the existing conditions.
     

Share This Page

For only 9.99$/year you can upgrade your account to RCTen Factory Team Member. Click for all benefits.
UpGradeRC