For only 9.99$/year you can upgrade your account to RCTen Factory Team Member. Click for all benefits.
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

How to Setup XPS ESC

Discussion in 'Batteries - ESCs - Motors Section' started by AERacer, Jun 13, 2012.

  1. AERacer

    AERacer Administrator Staff Member Moderator Factory Member

    Joined:
    May 30, 2012
    Messages:
    9,288
    Likes Received:
    2,028
    1. Turn the transmitter on
    2. Turn the ESC on
    3. Using a plastic tool, press and hold the ESC “SET” button for at least 3 seconds. The setup LED will flash red/green to confirm that the unit is in setup mode.
    4. Leaving the transmitter trigger at neutral, press the setup button once. The “Throttle Neutral” setting has been stored, and the setup LED is now green.
    5. Pull the transmitter trigger back to full throttle and press the setup button once. Release trigger. The “Throttle full” setting as been stored, and the setup LED is now red.
    6. Push the throttle trigger forward to full break and press the setup button once. The “Brake full” setting has been stored, and the setup LED flashes red/green 3 times simultaneously.
    7. Your XPS Electronic Speed Control has been set and your vehicle is ready to run. If you make a mistake during the setup procedure, don’t worry; disconnect the battery for about 10 seconds and start over with step 1.
     
  2. Don

    Don Well-Known Member Factory Member

    Joined:
    May 31, 2012
    Messages:
    52
    Likes Received:
    5

Share This Page

For only 9.99$/year you can upgrade your account to RCTen Factory Team Member. Click for all benefits.
UpGradeRC